This is a hand held diagnostic tool that is a must for all diagnosis of electrical circuits. It is a 20MHz Dual Channel Digital Storage Oscilloscope combined with Dual Channel True RMS Digital Multimeter to measure AC/DC Voltage, Frequency, Resistance, continuity and Diode Testing. It is battery operated and hand held instrument.

It has autoranging Voltage and Time Base. The vertical sensitivity can be varied from 500mV to 200V / Div in the sequence of 1, 2 and 5. The horizontal sensitivity can be varied from 50ns to 2 Secs in 1, 2 , 5 sequence. In the horizontal mode it has a record length (bytes) of 512 single shot and glitch capture and 256 other modes. The sampling rate in horizontal mode is 25MS/ Div. It has Single, Normal, Auto and Glitch modes. In the vertical part the sampling rate is 25MS/sec and the resolution is 8 bits. The coupling is AC, DC, GND. The input impedance is more than 1 M.Ohms. The display mode is CH1 and DUAL. The maximum input voltage is 600V rms. And has Free run and normal modes.

The trigger source is internal (CH1 / CH2). The slope is positive / negative and the sensitivity is 0.5 divisions or more between DC to 5MHz and 1.5 Div or more from 5 MHz to 20MHz. It has a 76 x 76 mm 240 x 240 pixels FSTN black & white CCFL Backlite LCD Display. Using optional adaptors temperature from -40 to 500 Degree F, Current from 0 to 400 / 1000A and pressure up to 500 psi can be measured. The voltage and Time base in the oscilloscope modes can be set manually or automatically. It has waveform and set-up memory and also has printer interface. It has two screen memories.

It has optically isolated RS-232 PC Interface. It is both battery and AC mains operated. It has trend plot facility. It comes complete with rechargeable battery pack, rubber test lead set, AC/DC adapter, instruction manual, boot with strap, alligator clip set, Software, RS232 PC interface cable and BNC adapter set. More details as per leaflet enclosed.